Heating System Installation in New Port Richey, FL

Central heating remains the most common setup in New Port Richey homes with existing ductwork. Our technicians install complete central heating systems that distribute warm air evenly through your home's duct network. We size every unit using Manual J load calculations to make sure the system matches your home's square footage, insulation levels, and layout.

If your current ductwork is outdated or leaking, we inspect and repair it before installing new equipment. A properly sealed duct system can improve heating efficiency by 20–30%, according to the U.S. Department of Energy.

Heat pumps are the go-to choice for Florida homes. They provide both heating and cooling from a single unit, which makes them cost-effective and practical for our climate. We install air-source heat pumps from trusted manufacturers and can replace aging units with newer, higher-SEER-rated models.

If your current heat pump is over 10–15 years old, a replacement can cut your energy usage significantly. Our team handles the full swap, disconnecting the old unit, installing the new one, charging the refrigerant, and testing performance.

While less common in Florida than in northern states, some New Port Richey homes use electric or gas furnaces. We install both types and can upgrade older furnaces to newer high-efficiency models. Electric furnaces are simpler to install in homes without gas lines, while gas furnaces deliver faster heat output.

Our technicians verify proper venting, gas line connections (where applicable), and electrical wiring before completing any furnace installation. Safety is non-negotiable.

Ductless mini-split systems work well for homes without ductwork, room additions, garages, and sunrooms. These units mount on the wall and connect to an outdoor compressor, no duct modifications required.

We install single-zone and multi-zone ductless systems. A multi-zone setup lets you control temperatures independently in different rooms, which reduces energy waste. Ductless mini-splits also run quieter than traditional systems, a benefit many homeowners appreciate.

A new heating system performs best with the right controls. We install programmable and smart thermostats that let you set schedules, adjust temperatures remotely, and monitor energy usage from your phone.

Zoning systems divide your home into separate temperature areas, each controlled by its own thermostat. This setup prevents you from heating unused rooms and can reduce energy costs by up to 30%. We install zone dampers, multiple thermostats, and the control panel needed to run the system.

Businesses in Pasco County need heating systems that handle larger spaces, higher occupancy, and stricter code requirements. R.J. Kielty installs commercial heating equipment for offices, retail spaces, warehouses, restaurants, and multi-unit buildings.

We work with building managers and property owners to design heating solutions that meet local building codes and keep operating costs manageable. Our commercial installations include rooftop units, split systems, and packaged heating and cooling systems.